Installation - Taurus BERGEN 16CR Gebrauchsanweisung

- Do not force the power cord. Never use the
power cord to lift up, carry or unplug the appli-
ance.
- Do not wrap the power cord around the appli-
ance.
- Do not clip or crease the power cord.
- Check the state of the power cord. Damaged
or tangled cables increase the risk of electric
shock.
- The appliance is not suitable for outdoor use.
- Supply cord should be regularly examined for
signs of damage, and if the cord is damaged,
the appliance must not be used.
- Do not use or store the appliance outdoors.
- Do not leave the appliance out in the rain or
exposed to moisture. If water gets into the
appliance, this will increase the risk of electric
shock.
- Do not touch the plug with wet hands.
- Do not touch any of the appliance's moving
parts while it is operating.
USE AND CARE:
- Fully unroll the appliance's power cable before
each use.
- Do not use the appliance if the on/off switch
does not work.
- Use the appliance handle/s, to catch it or move
it.
- Do not turn the appliance over while it is in use
or connected to the mains.
- Disconnect the appliance from the mains when
not in use and before undertaking any cleaning
task.
- Store this appliance out of reach of children
and/or persons with physical, sensory or
reduced mental or lack of experience and
knowledge.
- Make sure that dust, dirt or other foreign ob-
jects do not block the fan grill on the appliance.
- Keep the appliance in good condition. Check
that the moving parts are not misaligned or
jammed and make sure there are no broken
parts or anomalies that may prevent the appli-
ance from operating correctly.
- Never leave the appliance connected and un-
attended if is not in use. This saves energy and
prolongs the life of the appliance.
SERVICE:
- Make sure that the appliance is serviced only
by specialist personnel, and that only original
spare parts or accessories are used to replace
existing parts/accessories.
- CAUTION: There is a risk of fire if the appli-
ance's cleaning is not done according to these
instructions.
- Any misuse or failure to follow the instructions
for use renders the guarantee and the manu-
facturer's liability null and void.
DESCRIPTION
A Front guard
B Blade screw
C Blade
D Nut
E Rear guard
F Oscillation button
G Motor house
H Speed buttons
I Timer control
J Stainless pipe (**)
K Pipe locker
L Pole
M Cross base
N Fastening base feet
O Round base
(**) If you do not see this part, ensure it is not
located inside the lower base pole (L) before con-
tacting our technical service, remove it carefully
to avoid any damage.
If the model of your appliance does not have the
accessories described above, they can also be
bought separately from the Technical Assistance
Service.

INSTALLATION

- Ensure that the fan is switched off from the
supply mains before start any installation or
assembly operation.
- The plug must be easily accessible so it can be
disconnected in an emergency.
- The appliance should be used with its base
fitted.
ASSEMBLING THE CROSS BASE:
- Insert the feet in the fastening base (N) and
secure them with the screws provided (Fig.1).
ASSEMBLING THE ROUND BASE: