Petra KM 42 Gebrauchsanweisung Seite 24

KM42_75811270_100108_KM42_75811270_090821 12.12.11 14:58 Seite 24
The quality of the crema
is insufficient
The outlet drips for
a long time
The appliance switches off  The appliance may not be operated in locations, which are more than 1,500 m
during heating
Milk is not suctioned due
to the lack of steam
Milk froth splatters and is
very porous
The frothed milk does not
have sufficient foam
Milk froth runs continuously  The milk suctioning cup (31) should be at least 14 cm tall, otherwise the
The decalcification program  It is important that both buttons are pressed simultaneously. If you press one
does not start
Water escapes on the
handle of the pad cartridge
Water is located under
the appliance
 The powder cartridge (optional accessory) is free of any powder residue.
 The best crema quality will only develop after the appliance has been in use
for some time.
 Routinely decalcify and clean the filter insert (19). Observe the information in
section "Cleaning and Care".
 The two filters in the filter insert (19) may not be pushed together. However, if
this has occurred, it must be replaced.
 Always set the rocking lever (5) to
post-dripping.
above sea level.
 Wait until the start/stop button
the process a second time.
 Clean the steam nozzle (23) as described in section "Cleaning and Care".
 Push the tube adapter (26) up to the stop into the mixer (27) so that no gap is
visible at the handle. Twisting the tube adapter will not result in any changes.
 Clean the professional milk frothing unit.
 Remove contaminations on the air duct (29) of the tube adapter (26). Check if
its opening is open. A tube adapter (26) with a damaged air duct (29) must be
replaced.
 Use cold milk, directly from the refrigerator.
suctioning cup (31) could be suctioned empty after frothing (siphon effect).
Do not hang the tube (25) directly into a 1 liter Tetra pack.
button earlier, the decalcification program will not start. Try it again and only
release the buttons shortly after the pump starts.
 Check if the pad is properly located in the pad cartridge (6). If the paper edge
projects over the edge of the depression, the seal will no longer seal during
brewing.
 Empty the drip pan (8) in time.
 Only fill the water tank (4) up to the max mark.
 Never let the appliance stand over an extended period without the water tank (4).
24
after brewing, this prevents lengthy
(12) is again illuminated in green and attempt