Operation - FLORABEST 86285 Handbuch

The water flow regulators (E) can be used to regulate the water flow in the individual irrigation lines, but cannot be used to close
it off completely.
Connect the irrigation system to the water supply in accordance with Figure 2
Connect the tap connector (A) with the pressure reducer and filter to a water tap. Press the flexible pipe firmly into the pipe adap-
ter (D).
The drip irrigation set may only be operated in conjunction with the pressure reducer.
Use the screw adapter (B) to also connect the pressure regulator to an ordinary 13 mm (1/2") connection system for garden
hoses.

Operation

Before starting up, open all water flow regulators.
Turn on the tap and wait until the water has been distributed to the irrigation lines.
Check irrigation lines for correct sealing.
Set the required water amount per irrigation line using the water flow regulators.
The irrigation system can ideally be controlled using an irrigation timer or computer.
Before making changes to the irrigation system, turn off the tap.
Service
Abraham Diederichs GmbH & Co. oHG
Kundenservice
Hastener Straße 4 - 8
42349 Wuppertal – Germany
Tel: + 49 (0) 18 05 / 99 21 21
Fax:+ 49 (0) 2 02 / 6 98 05 88
adw-service@meister-werkzeuge.de
Please keep the hose installation details and the contact address.
ADW is a registered trademark of
Abraham Diederichs GmbH & Co oHG
Wuppertal, Germany
fb-9929023_MicroDrip_Man.indd 5 fb-9929023_MicroDrip_Man.indd 5 13.02.2013 11:19:47 Uhr 13.02.2013 11:19:47 Uhr