Klarstein Twister Handbuch Seite 19

If you hear a beep the first time the power plug is plugged into the mains outlet, it
means that the fan has been properly connected. When the device is in standby mode,
only the On / Off button can be pressed.
Symbol Function
On/Off
Level
Timer
Mode
Description
In standby mode, only this button is available.
After pressing this button the fan will be switched
on. The fan will run initially at low speed and in
normal mode. Timer and vibration functions will
be deactivated. The corresponding LED indica-
tors will light up. The operating status, which was
active at power off except for the timer and mode
function, will be automatically restored at power
up. If you press the On / Off button in the operat-
ing status, the device will enter standby mode.
Press this button to select the desired fan speed,
in order of low to high (levels). The correspond-
ing number will appear on the display up.
When you turn the unit on, the timer function will
be disabled. Press the TIMER button to set the
time until the unit automatically turns off. You can
choose between 1H-2H-4H-8H-no timer-1H, etc.
The corresponding LED indicator will light up. If the
timer has been activated, the device will run until the
countdown expires and then turn off automatically.
The initially set mode is 'Normal'. Press the Mode
button repeatedly to set a different wind mode.
You may select between 'Normal' - 'Sleep-
ing' - 'Natural' - 'Eco' - 'Normal' by repeat-
edly pressing this button. The corresponding LED
indicator will light up (except in Normal mode).
EN
19