cinetto B-moved PS48.2 Montageanleitung Seite 62

6. FAQ
6.1 Despite pressing the 'SET/RESET' button, the self-learning function is not activated
Check the system power supply. Make sure the power jack and power supply adapter cable are properly inserted.
6.2 The self-learning function does not work on all cabinet doors
Check that the motor to control unit connection has been made according to instructions and that the pins are properly inserted.
Check that the mechanical connection between the door and the movement bar has been made according to instructions.
Check that the system's wiring or other physical obstacles do not interfere with the door movement along its track or with the door
to movement bar connection.
Finally, unplug and re-plug the control unit power supply jack and press the 'SET/RESET' button on the control unit for three se-
conds.
6.3 The self-learning function did not memorize the track limits as expected
Check that the mass of each door does not exceed the maximum indicated in the sliding system specifi cations.
Check that the track limit stops supplied with the sliding system are positioned according to the installation instructions.
Check the correct levelling and installation of the furniture and the sliding system combined with it. Regarding the sliding system,
check that adjustments have been well effectuated and that there are no friction points between cabinet parts and sliding pads or
doors.
Check the levelling of the doors. If the structure of the door does not guarantee perfect levelling, the installation of a tensioner to
straighten the doors is recommended.
Check that there are no physical obstacles in the path of the door. Check that the system's wiring is not in the path of the door or
of the door to movement bar connection.
Finally, unplug and re-plug the control unit power supply jack and press the 'SET/RESET' button on the control unit for three se-
conds.
6.4 The supplied remote control does not work
Check that pairing has been successfully completed (see Section 3.4).
Check that you are using the buttons that are active for the chosen confi guration. See the specifi c instructions of the sliding arran-
gement combined with the 'B-Moved' system.
If pairing of the remote control still does not work, replace its internal battery (type CR2032 3V), by removing the screw on the
back of the remote control, and then repeat the pairing process indicated in Section 3.4.
6.5 The doors collide during movement
The system's logic should prevent collisions between the doors. In the event that any collisions occurs:
• Check that the wiring complies with the associated sliding system installation instructions;
• Unplug the power supply jack from the control unit, reposition according to instructions, re-plug the jack in the control unit
and wait at least 10 seconds;
• Activate the track limit self-learning procedure by pressing the 'SET / RESET' button for 3 seconds.
6.6 The appliance (e.g. interior light) connected to the switch does not work according to expectations
62