Machine Information; Technical Specifications - VONROC JS501DC Bersetzung Der Originalbetriebsanleitung

EN
could give the operator an electric shock.
• Keep hands away from the sawing range. Do
not reach under the workpiece. Contact with
the saw blade can lead to injuries.
• Apply the machine to the workpiece only when
switched on. Otherwise there is danger of kick-
back when the cutting tool jams in the workpiece.
• Pay attention that the base plate rests securely
on the material while sawing. A jammed saw
blade can break or lead to kickback.
• When the cut is completed, switch off the
machine and then pull the saw blade out of the
cut only after it has come to a standstill. In this
manner you can avoid kickback and can place
down the machine securely.
• Use only undamaged saw blades that are in per-
fect condition. Bent or dull saw blades can break,
negatively influence the cut, or lead to kickback.
• Do not brake the saw blade to a stop by applying
side pressure after switching off. The saw blade
can be damaged, break or cause kickback.
• Use appropriate detectors to determine if utility
lines are hidden in the work area or call the lo-
cal utility company for assistance. Contact with
electric lines can lead to fire and electric shock.
Damaging a gas line can lead to explosion. Pe-
netrating a water line causes property damage.
• Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held more
secure than by hand.
• Always wait until the machine has come to a
complete stop before placing it down. The tool
insert can jam and lead to loss of control over
the power tool.

2. MACHINE INFORMATION

Intended use
The machine is intended for sawing wood, metal,
plastics, ceramics, rubber, etc. to any required size
and in any required shape, while keeping the ba-
seplate resting firmly on the workpiece. A suitable
saw blade must always be used.
6

TECHNICAL SPECIFICATIONS

Model No.
Rated voltage
No load speed
Saw stroke
Max. saw capacity wood 0°
Max. saw capacity steel 0°
Weight
Sound pressure level L
PA
Sound power level L
WA
Vibration 'sawing sheet metal' 5.459 m/s
Vibration 'sawing plywood'
Only use the following batteries of the VONROC
VPOWER 20V battery platform. Using any other
batteries could cause serious injury or damage the
tool.
CD801AA 20V, 2Ah Lithium-Ion
CD803AA 20V, 4Ah Lithium-Ion
The following charger of the can be used to charge
these batteries.
CD802AA Quick charger
The batteries of the VONROC VPOWER 20V battery
platform are interchangeable with all the VONROC
VPOWER 20V battery platform tools.
Vibration level
The vibration emission level stated in this instruc-
tion manual has been measured in accordance
with a standardized test given in EN60745; it may
be used to compare one tool with another and as
a preliminary assessment of exposure to vibration
when using the tool for the applications mentioned.
• Using the tool for different applications, or with
different or poorly maintained accessories, may
significantly increase the exposure level.
• The times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work patterns.
JS501DC
20V
0-2500/min
25mm
50mm
8mm
1.85 kg
82.0 dB(A), K=3dB(A)
93.0 dB(A), K=3dB(A)
K=1.5 m/s
2 2
5.658 m/s K=1.5 m/s
2 2
WWW.VONROC.COM