Using The Adcim6Flushxx Flush Mount - American Dynamics illustra 625PTZ Aufbauanweisung

Using the ADCiM6FLUSHxx Flush Mount

The following describes the process for installation of the i625PTZ surface mounting base to the
ADCiM6FLUSHxx Flush Mount.
Note
This guide assumes that the ADCiM6FLUSHxx Flush Mount has been installed using the
installation guide provided with the product and that cables have been pulled to the site.
Step Action
1 Remove the surface mounting base from the dome.
Refer to Installing the Surface Mounting Base step 3.
2 Attach the fixing bracket to the surface mounting base with four M4x6 screws as seen in
Figure 9.
3 Feed the cables through the access hole.
4 Insert the fixing bracket into the mounting area in the ceiling.
Use a screwdriver to rotate the screws on both sides of the fixing bracket until the locking
arms, firstly splay out, and then tighten against the mounting surface.
5 Connect the cables to the dome.
Refer to Installing the Surface Mounting Base step 5 and 6.
6 Attach the dome to the surface mounting base.
Refer to Installing the Surface Mounting Base step 8.
Figure 9
English illustra 625PTZ Dome
11