Before You Begin - Kodak DX 4330 Easyshare Benutzerhandbuch

7.0 WINDOWS Installation Instructions

7.1 Before You Begin

Do not install the KODAK EASYSHARE Software with the camera connected to the
IMPORTANT:
computer or in the dock. Doing so may cause the software to be loaded incorrectly. If the
camera is connected, disconnect it before starting the installation procedure.
Make sure no other applications are running. Running applications are visible as rectangle icons in
the WINDOWS taskbar typically located at the lower middle part of your desktop.To close these
applications, right-click the rectangular taskbar icon and click Close.
7.2 Uninstall KODAK Picture Software
Uninstall previous versions of KODAK Picture Software, if they exist. Click Start>Settings>Control
Panel. (On XP, click Start>Control Panel.) Double-click Add/Remove programs. Look for the
following applications in the application list on the left pane of the Add/Remove window:
• KODAK Camera Connection Software
• KODAK Picture Transfer Software
• KODAK Picture Software
Highlight each of these applications, then click Add/Remove. A wizard guides you through the
process. When the process is complete, restart your computer.
7.3 Remove KODAK EASYSHARE Software
Remove KODAK EASYSHARE Software if it is installed.Click Start>Settings>Control Panel. (On
XP, click Start>Control Panel.) Double-click Add/Remove programs. Look for KODAK
EASYSHARE Software in the application list on the left pane of the Add/Remove window. Highlight
the application, then click Add/Remove. A wizard guides you through the process.
NOTE: If any applications were removed, make sure you restart the computer before proceeding to
the next section.
20 July 25, 2002