Baumatic F60.2 Anleitung Seite 6

whether you want to use it as a suction
ventilator. See page 18 for the explanation
about the differences.
•
The cooker hood must not be installed
above the cookers with radiant plate.
•
It is recommended to install the device
in cooperation with another person.
Note
Your cooker hood Baumatic should be
installed on the wall only. DO NOT
INSTALL IT lower than 700 mm (70 cm)
above the cooking surface.
1. Remove metal grease filter (see Fig. 1).
2. Set the cooker hood against the wall
and mark the position of auxiliary holes
(you need to bore them, see the
illustration below). The auxiliary holes
are shown in Fig. 2 (over the page),
marked "D", along with the anchoring
holes marked "E"(Fig. 2 (over the
page). If your type of the cooker hood
is provided with a suspension eye, use
the eye as the guide for marking the
holes to be bored.
3. Bore the holes in the wall at the
positions marked before; use the
drilling tool size 6 mm (see Fig. 3).
4. Insert dowel pins in the holes and half-
screw the auxiliary bolts in (see Fig. 4).
5. Hang the cooker hood on the bolts
(see Fig. 5) and fix it on the wall –
tighten the auxiliary and anchoring
bolts well-tight (over the page, at the
top).
Fig. 1 – Grease filter
6. (ONLY FOR THE SUCTION
FUNCTION ) Install the connecting
attachment on the upper part of the
cooker hood (see Fig. 6).
After that, connect the discharge pipe
(see below). Remember that the pipe
must comply with the specifications as
listed in the Notes about the suction
mode / air cleaning (recirculation).
5