Instructions For Installation - Baumatic F60.2 Anleitung

Note
1. Ask for the installation a properly
qualified and knowledgeable
technician.
2. The manufacturer is not responsible
for any damage or injury originating
from not respecting the instructions for
installation in the text below.
The cooker hood is used in the electric
network 220/240 V, 50 Hz.
CHARACTERISTICS
1. The cooker hood is made of top quality
materials. Its shape is rounded and
aerodynamic.
2. The device is provided with an efficient,
nearly silent electric motor; a centrifugal
ventilator characteristic with strong
suction power and low noise level; and
an easy-to-clean grease filter.
Good
3. By use of an insulated control panel
powered from low voltage source 12
V DC, the lights are safer.
4. The special construction of the air
tunnel and the shape of oil catcher
allow catching any free dirt in a
second.
INSTALLATION
1.
2.
3.
4.
Wrong
INSTRUCTIONS FOR
INSTALLATION
Remember that before you start any
installation activity, you have to decide
4
Before the installation, make sure
that the room is clean - avoid suction
wooden chips or dust.
The device must not share the same
ventilation pipe with other devices
e.g. gas oven, heating oven or hot
air oven.
The angle of the bend of the
ventilation pipe should not be less
than 120º; you must direct the pipe
horizontally, or, alternatively, the
pipe should go up from the initial
point and should be led to an outer
wall.
After the installation, make sure that
the cooker hood is placed
horizontally – avoid collecting the
grease at one end.