Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5.
Mark the side position of the moving
cover "B" and let it go back down (see
Fig. 8).
6.
Now, take the fixing holder "G" (Fig. 7-
previous page), centre it (follow the
marks), while the holder is still touching
the ceiling, and mark the anchoring
holes ("H").
7.
Bore the holes in the wall at the
positions marked; use the drilling tool
size 6 mm (see Fig. 9).
8.
Insert dowel pins in the holes, holder "G"
(Fig. 7, previous page), place them
properly, and tighten with the bolts
(included in the supply).
9.
Lift the cover "B" up to the ceiling and fix
it to the holder "G": insert the bolts in the
holes "M" (Fig. 7 on previous page).
Installation of the glass (Fig. 11)
•
Remove metal grease filters from the
cooker hood
•
Loosen both anchoring bolts "F"
•
Place the glass "Q" on the upper
surface of the cooker hood and push it
towards the wall.
•
Once, more, tighten the bolts "F" in the
hole, and fix them to the unit.
•
Make sure that the anchoring corner is
fixed properly and well tightened.
•
Reinstall the ventilation pipe with the
connecting attachment "N".
•
WARNING! DO NOT TIGHTEN THE
BOLTS TOO MUCH OR YOU
DAMAGE / DEFORM THE SHAPE OF
THE UNIT.
Suction function
Make sure you have installed the
connecting attachment ("N") on the upper
part of the cooker hood by means of two
bolts (Fig. 1 right). By means of a pipe,
diameter 125 mm, connect the attachment
(N) on the upper part of the cooker hood
(see Fig. 12) with the pipe intended for
removal of kitchen vapour, section at least
150 cm2.
Note
If you do not have any pipe able to remove
the vapour, and the cooker hood is to be
installed on an outer wall of the building:
make a hole in the wall, large enough for
installation of a ventilator and a rainproof
ventilation grid, section at least 150 cm2.
Connect it to the output attachment by
means of a pipe.
Note
For the suction function, you need to
connect the 125 mm pipe to the point "N",
see Fig. 1 above. The pipe is not included
in the supply of the cooker hood.
The function of air cleaner (recirculation)
The cooker hood may be adjusted to serve
as an air cleaner in case that you cannot
install the external pipe for the air exhaust.
If this is the case, the air is recycled
through the airing hole. If you use the unit
as the air cleaner, you have to install two
filters with active carbon in order to absorb
kitchen vapour.
9
Werbung
Inhaltsverzeichnis
