Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Safety warning
•
Never allow children to operate the
device.
•
The cooker hood is intended only for
households: it is not designed or
intended for barbecue, fast food shops,
or other commercial use.
•
Always ask a qualified technician to
install the device.
•
You should clean the cooker hood and
its filter grid regularly – to maintain its
proper operation.
•
Before you start any cleaning, switch
the main switch off and disconnect
from the power.
•
At cleaning the cooker hood, follow the
instructions in this manual. Prevent
burning the cooker hood.
•
If you detect any failure of defect,
contact the service centre.
HOW TO ADJUST SPEED
Electronic button
1.
Switch the air input on. You will hear
an audio signal- five beeps. The
sound is just a signal to say that the
device is connected to the power.
2.
Press the "Low" button. The indicator 1
is lit, one beep is generated, and the
motor will run at low speed. Press the
button again. The motor is stopped.
3.
Press the button "Mid". The indicator 2
is lit, the audio system generates one
beep, and the motor is running at
medium speed. Press the button
again. The motor is stopped.
4.
Press the "High" button. The indicator
3 is lit, one beep is generated, and the
motor will run at high speed. Press the
button again. The motor is stopped.
5.
Press the button "Light". The indicator
4 is lit, and the two bulbs of the cooker
hood start shining. If you press the
button again, the lights are switched
off. Any press of the button is
accompanied with one audio signal.
Buttons
1.
Press the button "Stop". The motor is
stopped then.
2.
Press the button "Low". One beep is
generated, and the motor is running at
low speed.
3.
Press the button "Mid". One beep is
generated, and the motor is running at
medium speed.
4.
Press the button "Low". One beep is
generated, and the motor is running at
low speed.
5.
Press the button "Light": both lights
start shining. Press the button again.
The lights are switched off then.
Movable control element
a)
Plug the device in the socket.
b)
Move the control element
position "I". The bulb is lit. Then, shift
12
in the
Werbung
Inhaltsverzeichnis
