Siemens KI86SGD30 Gebrauchsanleitung Seite 41

Fault
Warning signal
sounds, "alarm"
button lights up.
Fig. 2/5
The freezer
compartment is too
warm!
Frozen food is at risk!
Freezer compartment
temperature display
flashes. Fig. 2/4
Warning signal
sounds.
The alarm button is lit.
Fig. 2/5
The freezer
compartment is too
warm!
Frozen food is at risk!
Freezer compartment
temperature display
flashes. Fig. 2/4
Appliance is not
cooling, temperature
display and light
are lit.
Possible cause
Appliance is open.
Ventilation openings
have been covered.
Too much food was
placed in the freezer
compartment at once.
Appliance is open.
Ventilation openings
have been covered.
Too much food was
placed in the freezer
compartment at once.
A fault caused the
freezer compartment
to become too warm
in the past.
Showroom mode is
switched on.
Remedial action
To switch off the warning signal,
press the "alarm" button 5.
Close the appliance.
Ensure that there is adequate
ventilation.
Do not exceed max. freezing
capacity.
When the fault has been eliminated,
the "alarm" button 5 goes out
shortly afterwards.
To switch off the warning signal,
press the "alarm" button, Fig. 2/5.
Close the appliance.
Ensure that there is adequate
ventilation.
Do not exceed max. freezing
capacity.
When the fault has been eliminated,
the alarm display goes out shortly
afterwards.
When the alarm button 5 is pressed,
the temperature display stops
flashing. Fig. 2/4
The temperature display indicates
for 5 seconds the warmest
temperature which was reached
in the freezer compartment.
Hold down alarm button, Fig 2/5,
for 10 seconds until an
acknowledgement signal sounds.
After a short time check whether
your appliance is cooling.
en
41