Troubleshooting - Probuilder 69380 Gebrauchsanweisung

Troubleshooting

Problem
Air leaking from top of nail
gun or around trigger.
SømpistolAir leaking from
bottom of staple gun or
between gun and cylinder
head.
Brad nails or staples driven
too deep.
Nail gun is not working
properly or is not driving in
staples properly.
Nail gun skips brad nails or
staples.
The brad nails or staples get
stuck in the magazine.
30
Cause
The trigger valve is
damaged.
1. Loose screws.
2. O rings worn or
damaged.
1. Loose screws.
2. Supply air pressure
excessive.
1. Supply pressure too low.
2. Nail gun needs
lubrication.
3. O-rings or gaskets are
damaged or nail gun is
defective.
1. Magazine spring is
defective.
2. Front plate or magazine
defective or dirty.
3. Cylinder ring defective
orneeds lubrication.
4. Nail gun is defective.
1. Wrong type of brad nails
or staples are being used
or have been inserted
incorrectly.
2. Magazine loose or dirty.
3. Nail gun is defective.
Solution
Have the air gun inspected
and repaired.
1. Tighten screws
2. Have the air gun
inspected and repaired.
1. Tighten the screws.
2. Reduce pressure.
1. Increase pressure.
2. Lubricate nail gun.
3. Have the air gun
inspected and repaired.
1. Replace spring.
2. Clean front plate or
magazine.
3. Lubricate nail gun.
4. Have the nail gun
repaired.
1. Use correct type of brad
nails or staples, or check
they are loaded correctly.
2. Fit magazine correctly
and check it is clean.
3. Have the air gun
inspected and repaired.