H - Cleaning The Suction Filter; I - Replacing The Fuses; L - Wiper Adjustment - Wirbel RAPID 40 E 55 TOUCH Gebrauch Und Wartung

www.ghibliwirbel.com
Professional Cleaning Machines Since 1968
9.1.h - Cleaning the suction filter (Fig.
18)
- Lift the filter with its cover (62).
- Loosen the screw (63) and remove the
filter (64).
- Wash the filter (64) in running water and
reassemble it in reverse order.

9.1.i - Replacing the fuses

(Figg. 8-19)
WARNING:
Replace the blown fuse with one with the
same amperage.
- Remove the plug (16 Fig. 8) from the
socket (43 Fig. 8).
- Remove the cover (65 Fig. 19) unscrew-
ing the screws (66 Fig. 19) to access the
fuse.
- Remove the cover sheet and replace the
fuse. Put the cover (65 Fig. 19) back.
9.1.l - Wiper adjustment (Fig. 20)
- It is possible to adjust the height of the
wiper and adjust the incidence of the
blades on the floor.
Height adjustment (only if necessary)
- The height is adjusted at the time of con-
struction of the machine, then change it
only when absolutely necessary.
- Loosen the screw (67) and lift or lower
the wheel (68) until the wiper is in the
desired position, then tighten the screw
(67).
Incidence adjustment
- Lower the wiper, using the lever.
- Start the aspirator and proceed for a few
metres, then turn off the aspirator and
stop the machine.
- Check the incidence of the rubber (50)
blades.
Fig. A = too low
Fig. B = too high
Fig. C = correct position
- Use the grey knob (69) for adjustment,
turning it anticlockwise to increase the
incidence and in the other direction to de-
crease it.
ENGLISH - 11