Control Panel; Filling The Tank; Operation; A - Checks Before Use - Wirbel RAPID 40 E 55 TOUCH Gebrauch Und Wartung

5.1 CONTROL PANEL

(Fig. 9)
20) Rotating handle for brush rotation
By acting on the rotating handle (20) with
the switch (34) "
" and the switch (39) "
it starts the rotation of the brush and the
water supply.
34) Main switch
With the plug inserted, it lights up, indicat-
ing the presence of voltage.
Pressed in "I" position, it gives the voltage
to other switches.
Pressed on "0" it stops.
35) Suction unit activation switch
The operation of the switch is enabled by
the switch (34) in position "I".
By pressing the power switch to "I" starts
the operation of the vacuum.
37) Operating hour indicator
Indicates the machine operating hours.
38) Brush rotation enabling switch
Press the switch (38), it enables the ro-
tation of the brush; the operation of the
same is controlled by the rotary handle
(20). To disable the rotation of the brush,
press the switch (38) "
39) Water solenoid valve switch
The operation of the switch is enabled by
the switch (38) in position "I".
Press the switch (39), it prepares the
opening of the solenoid water valve, the
operation thereof is controlled by the ro-
tary handle (20).
The amount of water is controlled by the
tap (4).
4) Water quantity adjustment tap
Turn the tap (4) counter-clockwise to
increase the quantity of water or turn it
clockwise to decrease it.
", the switch (38) "
" pressed,
".
ENGLISH - 6
Professional Cleaning Machines Since 1968

6.1 FILLING THE TANK

(Fig. 7)
WARNING:
Only add clean mains water to the tank at
a temperature no greater than 50°C.
- Remove the hose (26) supplied, connect
one end (26a) to a tap and insert the oth-
er end (26b) in the tank (5).
- Check that the tap (40) is open.
- Turn on the tap and fill the tank (5) to the
MAXIMUM LEVEL (NOT EXCEED) indi-
cated by the label placed on the transpar-
ent tube (15).
- Pour the liquid detergent into the tank for
machines not equipped with chemical kit.
N.B.:
Use non-foamy detergents only. For the
quantities, follow the instructions provided by
the detergent manufacturer according to the
type of dirt.
DANGER:
If the detergent comes in contact with the
eyes and/or skin or if swallowed, refer to
the use and safety information booklet
provided by the manufacturer of the de-
tergent.
7.1 OPERATION (Fig. 8)

7.1.a - Checks before use

- Check that the exhaust tube (12) of the
recovery tank is properly coupled and
properly sealed.
- Check that the connector (41) on the
squeegee (11) is not blocked and that the
hose is connected correctly.
- Check that the clean water exhaust tube
(15) is correctly coupled to the supports
and that the tap (40) is open.
www.ghibliwirbel.com