Makita DDF470 Bedienungsanleitung Seite 6

Indicating the remaining battery capacity
Fig.3
When you pull the switch trigger, the LED display shows
the remaining battery capacity as the following table.
LED indicator status
013980
NOTE:
The LED display goes off approximately one
•
minute after releasing the switch trigger to save
the battery power. To check the remaining battery
capacity, slightly pull the switch trigger.
When the LED display lights up but the tool does not
•
work even with a recharged battery cartridge, cool
down the tool fully. If the condition does not change,
have the tool repaired by a Makita local service center.
Switch action
Fig.4
CAUTION:
Before inserting the battery cartridge into the tool,
•
always check to see that the switch trigger
actuates properly and returns to the "OFF"
position when released.
To start the tool, simply pull the switch trigger. Tool
speed is increased by increasing pressure on the switch
trigger. Release the switch trigger to stop.
Lighting up the front lamp
Fig.5
CAUTION:
Do not look in the light or see the source of light directly.
•
Pull the switch trigger to light up the lamp. The lamp keeps
on lighting while the switch trigger is being pulled. The
lamp goes out 10 -15 seconds after releasing the trigger.
NOTE:
When the tool is overheated, the tool stops
•
automatically and the lamp starts flashing. In this
case, release the switch trigger. The lamp turns off
in one minute.
Use a dry cloth to wipe the dirt off the lens of the
•
lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
Remaining battery capacity
About 50% or more
About 20% - 50%
About less than 20%
Reversing switch action
Fig.6
CAUTION:
Always check the direction of rotation before
•
operation.
Use the reversing switch only after the tool comes
•
to a complete stop. Changing the direction of
rotation before the tool stops may damage the tool.
When not operating the tool, always set the
•
reversing switch lever to the neutral position.
This tool has a reversing switch to change the direction
of rotation. Depress the reversing switch lever from the
A side for clockwise rotation or from the B side for
counterclockwise rotation.
When the reversing switch lever is in the neutral
position, the switch trigger cannot be pulled.
Speed change
Fig.7
CAUTION:
Always set the speed change lever fully to the
•
correct position. If you operate the tool with the
speed change lever positioned halfway between
the "1" side and "2" side, the tool may be
damaged.
Do not use the speed change lever while the tool
•
is running. The tool may be damaged.
If the tool speed is coming down extremely during
•
the operation with "2", slide the lever to the "1" and
restart the operation.
Position of speed
Speed
adjusting lever
1
Low
2
High
013983
To change the speed, switch off the tool first. Select the
"2" side for high speed or "1" for low speed but high
torque. Be sure that the speed change lever is set to the
correct position before operation.
Adjusting the fastening torque
Fig.8
The fastening torque can be adjusted in 17 steps by
turning the adjusting ring. Align the graduations with the
arrow on the tool body. You can get the minimum
fastening torque at 1 and maximum torque at
The clutch will slip at various torque levels when set at
the number 1 to 16. The clutch does not work at
the marking.
6
Torque
Applicable operation
High Heavy loading operation
Low Light loading operation
marking.