Electrical Connection - System4 06WCP1GM Bedien- Und Installationshandbuch

ELECTRICAL CONNECTION

Important
The connection must be made by authori-
sed, skilled personnel, in accordance with
the relevant legal requirements, using ap-
propriate and specified materials.
The appliance is supplied with operating
voltage 230V/1N.
Caution - warning
Before doing any work, cut off the mains
electricity supply.
Connect the appliance to the mains electricity sup-
ply as follows.
1 - If not already present, install a circuit-breaker
(A) with overload cutout and differential safety
breaker close to the appliance.
IT
GB
DE
FR
CONVERSION OF GAS SUPPLY
The constructor has tested the appliance with its
ES
own mains gas, identified by the sticker applied to
the nameplate.
If the type of gas to be connected is different from
that used for testing, proceed as follows.
1 - Turn off the gas supply tap (A).
2 - Change the burner nozzle (see page 20)
3 - Change the pilot light nozzle (see page 20)
4 - Adjust the minimum settings of the gas control
valves of the burners (see page 18)
5 - If necessary, adjust the burner primary air (see
page 19)
English
A
2 - Undo the screws (B) and remove the control
panel (C).
3 - Connect the circuit-breaker (A) to the terminal
board (D) of the appliance as shown in the dia-
gram and in the electrical system diagram at
the back of the manual. Use a flexible cable
with at least type H07RN-F characteristics, ra-
ted for an operating temperature of at least
80°C.
Important
When connecting, take care over the con-
nection of the neutral and earth wires; if
they are not connected correctly, the bur-
ner does not light.
4 - Tighten the cable gland (E).
5 - Tighten the cable gland (F).
6 - Replace the control panel (C) on completion of
the operation.
B
C
A
- 16 -
D
E
F
IDM-39617400400.tif
IDM-39610801300.tif