Setting Bios; Installing Driver Software; For Windows 3.1X, Windows For Workgroups 3.11 Users - Fujitsu DynaMO 640 AI Benutzerhandbuch

4) Replace the PC cover and re connect AC power cable.

2.4 Setting BIOS

Most PC systems recognize the DynaMO 640AI drive with no changes to
system BIOS.
If your PC fails to recognize the DynaMO 640AI drive by assigning it with a
drive letter, you may need to disable BIOS auto-detection or set to "NONE" for
the DynaMO drive.
See your PC system manual for instructions. See Section 3 Trouble Shooting.

2.5 Installing Driver Software

Note: When using the "Installer and formatter for Windows NT 4.0" or the
"formatter for OS/2", a SCSI identification number is assigned for the
DynaMO 640AI and its device name is indicated as M25-MCC3064.
Please note that this is a normal operation.

2.5.1 For Windows 3.1x, Windows for Workgroups 3.11 users

1. Start Windows 3.1x or Windows for Workgroup 3.11.
Use care when replacing your PC cover. Be
careful not to loosen or damage any of the cables
in your PC.
• Before installation, terminate all other
applications that are running.
• The following instruction procedure assumes that
the drive letter for CD-ROM drive is E:. If the
CD-ROM drive has a different drive letter, please
use the appropriate drive letter.
1.17