Operation - Lightmaxx Vega Haze 900 Bedienungsanleitung

Operation:

Connect the product to the power supply and then turn it on. Wait until the heating element has
reached the operating temperature. Control is now either via DMX or via operation on the device.
Make sure that all cables used for operation (current and control) are subject to the applicable local
regulations and are undamaged.
Place the product in a safe, ventilated area. Ensure that untrained personnel do not have access to
the product. Keep a minimum distance of 50cm from walls and only use the fog machine on suita-
ble, non-combustible surfaces. For installations on trusses, always use a safety wire in accordance
with local regulations and approved xing equipment.
Resistance 120 ohm 1/4w between pin 2 (DMX-) and pin 3 (DMX+) of the last fi xture.
16
WARNING! (Risk of injury due to falling down)
Improper installation can cause considerable injury and damage!
The installation of the device should always be carried out by experienced per-
sonnel and must be carried out in compliance with the mechanical and electrical
safety regulations in your country.
Hint! (Fog fl uid)
Disconnect the device from the mains before fi lling!
Do not fi ll with hot liquids!
Only use high-quality water-based fog fl uids recommended by your dealer.
Other fog fl uids can lead to clogging or dripping of the device.
Suitable fog fl uid:
LightmaXX Premium DJ FLUID Fog Fluid 5L Standard Fog - LIG0007239-000
The fog fl uids recommended by the manufacturer are environmentally harmless
and can be disposed of via the sewer.
Make sure that there is always a suffi cient amount of fog fl uid in the tank.
A too low tank level can lead to pump damage and overheating of the heating
element during operation!