Cleaning Operations - Faema MD3000 Gebrauch Und Installation

9.2 User Menu: Configuration
Drawing mode setting
The measure grinder can be set with 2 different drawing
modes, which can be set by the user by entering the dedicated
menu.
1) press the icon from the
main screen::
2) The following is displayed:

10. Cleaning Operations

For correct application of the food safety system
(HACCP), please follow the instructions in this
paragraph.
General
To be performed at the end of the working day.
The grinder-doser should be cleaned periodically, with special
attention given to those areas that come into contact with the
coffee.
To clean, follow these procedures:
Always switch off the appliance at switch (11) and cut off from
the mains via the omnipolar switch.
Do not immerse the appliance in water.
Cleaning the coffee beans receptacle (2)
Close the gate (3) pulling it towards the outside and separate
the coffee beans receptacle (2) from the grinder-doser.
Remove any remaining coffee from the coffee beans receptacle
(2).
Wash the receptacle with a damp cloth using methods and
detergents suitable to objects that come into contact with
foodstuffs. Rinse thoroughly and dry, removing any organic
residue.
Before replacing the coffee beans receptacle (2) on the grinder-
doser, ensure that all the parts have been dried thoroughly
U S E R M E N U
D O S I N G
C O U N T E R S
C o n F I g U R A T I o n
3) Press the CONFIGURATION
item; the following is
displayed:
4) Select the desired drawing mode by pressing the relating
icon, then confirm it by pressing the
The chosen setting, M (Manual) o P (Pre-selection), is
shown below on the left on display:
M
Bodywork
Clean the bodywork of the appliance with a soft cloth and
use products that DO NOT contain ammonia or abrasive
substances. Remove any organic residue.
N.B. Do not spray liquids inside the openings of the appliance.
2
24
C o n F I g U R A T I o n
M A N U A L
P R E S E L E C T I O N
icon.
P
CLOSE
3
11