Ipod - Yamaha RX-V765 Bedienungsanleitung

Problem
External components The remote control code is not correctly
cannot be controlled
set.
by the remote control.
Even if the remote control code is
correctly set, there are some models that
do not respond to the remote control.
The remote control
The batteries of this remote control and/or
does not learn new the other remote control are too weak.
functions.
The distance between the two remote
controls is too long or too short.
The signal coding or modulation of the
other remote control is not compatible
with this remote control.
Memory capacity is full.

iPod™

Note
• In case of a transmission error without a status message appearing on the front panel display and on the OSD, check the connection of your iPod
(see page 19).
Problem
Loading...
This unit is in the middle of recognizing
the connection with your iPod.
This unit is in the middle of acquiring
song lists from your iPod.
Connect error
There is a problem with the signal path
from your iPod to this unit.
Unknown iPod
The iPod being used is not supported by
this unit.
iPod Connected
Your iPod is properly placed in the
Yamaha iPod universal dock.
Disconnected
Your iPod is removed from the Yamaha
iPod universal dock.
Unable to play
This unit cannot play back the songs
currently stored on your iPod.
Cause
Set the remote control code correctly using "List of
remote control codes" at the end of this manual.
Try setting another code of the same manufacturer
using "List of remote control codes" at the end of this
manual.
If this unit does not work when you press
do the following.
When the key does not work during DVD disc menu
operation: press the eInput selection keys on
the remote control again.
When the key does not work during OPTION menu/
SETUP menu operation: press the key applicable for
the current menu operation again.
Replace the batteries.
Place the remote controls at a proper distance.
Learning is not possible.
Delete unnecessary functions to free some memory
space for the new functions.
Cause
Turn off this unit and reconnect the Yamaha iPod
universal dock to the DOCK jack of this unit.
Remove your iPod in the Yamaha iPod universal dock
and then place it back in the dock.
Connect an iPod supported by this unit.
Check that the songs currently stored on your iPod
are playable.
Troubleshooting
Remedy
k Cursor,
Remedy
See
page
55
55
—
9
56
—
57
See
page
19
19
—
—
65
En