Fakir trend TS 121 Bedienungsanleitung Seite 43

Fault
Appliance does not work. Plug is not inserted or
Appliance suddenly
stops vacuuming.
Vacuum cleaning is
unsatisfactory.
Dust bag lid won't close.
Troubleshooting
Possible cause
the appliance is not swit-
ched on.
Power outlet does not
carry any power.
Power cord is damaged.
Overheat protection has
tripped (possibly due to
clogged suction chan-
nels, dirty filters, etc.)
Dust bin is full.
Filter is dirty or clogged.
Nozzle, telescopic
suction tube or suction
hose are clogged up.
Suction regulator is
open.
The power setting does
not suit the flooring.
Dust bag is not inserted
correctly.
Solution
Insert the plug into a
mains socket and switch
on the appliance.
Test the appliance at
another socket which
you are sure carries
current.
Have the power cord re-
placed by an authorised
Fakir service centre.
Switch off and unplug
the appliance. Eliminate
the cause of overheating
(e.g. clogged suction
channels, dirty filters,
etc.). Wait 30 minutes
and let the appliance
cool down. Then switch
on the appliance again.
Empty dust bin.
Clean or change the
corresponding filter.
Eliminate clogging. If ne-
cessary, use a wooden
stick (e.g. a broomstick)
to do this.
Close suction regulator.
Set the power to the
setting suggested for the
flooring.
Check if the dust bag is
installed properly.
19