Installation; Unpacking The Machine; Mounting The Lower Brace (02) - AL-KO ST 4048 Betriebsanleitung

GB
■
Push the appliance forwards
when clearing snow and
never go backwards. Never
pull the appliance towards
your body.
■
Do not move the appliance
over obstacles such as
branches or tree roots.
■
Switch off the motor if it is ne-
cessary to cross another area
than the area to be cleared.
■
After contact with dangerous
objects and foreign bodies,
check the appliance for dam-
age. Have the appliance re-
paired if it has been damaged.
36

4 INSTALLATION

WARNING!
Danger if assembly is
not carried out com-
pletely!
Operation of an incom-
pletely assembled appli-
ance can result in serious
injury.
■
Only operate the appli-
ance when it is fully as-
sembled.
■
Do not insert the battery
into the appliance until it
is fully assembled.
■
Check that all safety
and protective devices
are in place and func-
tioning correctly before
switching on.
4.1

Unpacking the machine

1. Remove all parts from the packaging.
2. Check that all parts have been delivered (see
chapter 2.3 "Scope of supply", page 31).
3. Check all parts for transport damage.
If any damage is evident or parts are missing,
immediately inform the dealer where the ap-
pliance was purchased.
4.2

Mounting the lower brace (02)

1. Position both ends of the lower brace (02/1)
against the pipe ends (02/2) (02/a) in such a
way that the insertion holes of the lower
brace and the pipe ends line up.
2. Insert two long locking screws (02/3) from the
inside.
3. Place a washer (02/4) on each of the locking
screws.
4. Screw star handles (02/5) onto the locking
screws and firmly tighten.
Installation
ST 4048