Additional Safety Instructions - Collomix CMG 1700 Originalbetriebsanleitung

Additional safety instructions

cooled down. Diamond cup disks become very
Use a dust extractor when grinding stone. The
The use of these devices reduces
the hazards of dust.
Do not grind any materials or workpieces con-
taining asbestos.
stance.
both hands.
Secure the workpiece.
than when held by hand.
Avoid any blockage of the diamond cup disk
or excessive contact pressure during grinding.
its load and its vulnerability, i.e. it can easier get
stuck or blocked and the risk of recoil or break-
age of the grinding disk is increased.
disk gets blocked or you need to interrupt
your work for any reason. Hold the power tool
Do not switch the power tool back on while
it is in contact with the workpiece.
grinding disk to reach its full speed before re-
commencing work.
hood opened along wall edges.
hood must always be closed when working on
Check the device, cable and plug before each
use. Any damage detected must only be re-
When working outdoors, operate the machine
with a residual current operated circuit-break-
er (RCD) with max. 30 mA.
Pull the mains plug and check that the main
moval work, in case of a voltage drop, or when
This will prevent any sud-
Do not use the machine if any part of the hous-
on the switch, power line or plug.
grinding disk is equal to or higher than the mo-
tor speed of the machine. Only use appropriate
accessory parts.
The exterior diameter of the grinding cup must
match the measurements provided on the
power tool.
actly onto the grinding spindle of your power
tool.
Diamond cup disks must only be used for their
The device may only be operated with the pro-
Only use cup wheels which are smaller than
Replace the lamellar ring when it is worn.
Connect the
-
-
-
Rev. 3 / 13
chine before use and comply with the
chine.
The use of a face mask is recommended
for dust-intensive tasks.
-
-
-