Adjusting The Handle - Collomix CMG 1700 Originalbetriebsanleitung

Assembly
Disconnect the mains plug from the wall
plug before carrying out any tasks on the device.

Adjusting the handle

Open the two wing nuts left and right and move
the handle to the desired position. Tighten the
wing nuts again.
Mounting the diamond grinding disk:
Select a diamond grinding disk that matches the
cessed.
Only use diamond grinding disks that comply with
the data listed in the table below.
hole in the diamond cup wheel.
The permissible rotational speed of the diamond
grinding disk used must at least match with the
data listed in the following table.
Please note the data provided on the diamond
grinding disk regarding its rotational and circum-
ferential speed.
max D
d speed [min
125 22.2 12250
ed spindle using the socket spanner provided.
it engage.
spindle to stabilise the cup wheel. When work-
ing with the suitable Collomix diamond cup
place. Do not operate the device without the
nut and spacer disk.
nut (10) on the threaded spindle. Press and
prevent the spindle from turning.
running before switching on the machine. The
disk must not come into contact with the pro-
The cup wheel can heat up during use. Leave to
cool. You could burn your hands or cut/ tear your
work gloves when changing tool inserts.
any material load. Interrupt your work immediate-
Only use original accessory parts!
-
max. height
-1
80 22
-
Rev. 3 / 14
6
7
8