AEG Electrolux KAM 200 Gebrauchsanweisung Seite 17

822_949_330 KAM200.book Seite 17 Donnerstag, 17. Januar 2008 9:49 21
0 Button
(Figure 2/C) is for
2-4
selecting the aroma setting (symbol
lights).
0 Pressing the button
changes between the number of cups
and , the aroma setting remains
on.
0 To cancel the aroma setting, press
button (Figure 2/G), the symbol
2-10
will go out and the number of
cups lights.
5.1 Preparing coffee instantane-
ously (Normal mode)
0 Pour in water (Item 1.2).
0 Swing out the swivel filter (Figure 1/B).
0 Insert filter paper (Item 1.3).
0 Swing the swivel filter back.
0 Place coffee jug on the warming plate
(Item 1.4).
0 Swing out the water supply (Figure
1/D) using the swivel lever (Figure 1/H)
until it engages (Figure 13).
0 Set the desired number of cups with
the button
2-10
0 Set the desired coffee strength with
the button
0 Where applicable (when preparing a
max. of 4 cups) select the aroma set-
ting with button
Example:
You require e.g.: 4 cups: medium
strength, with aroma setting
– the display shows:
Press button
red indicator will come on. Grinding
will begin at once. Once the coffee has
been ground, the water supply swings
back automatically to the brewing
position and brewing begins.
As long as the red indicator next to
3
button (Bild 2/B) is on, only the
button will work.
again
2-4
0 Pour in water (Item 1.2).
0 Swing out the swivel filter (Figure 1/B).
0 Insert filter paper (Item 1.3).
0 Swing the swivel filter back.
0 Place coffee jug on the warming plate
0 Swing out the water supply (Figure
0 Press button
3
(Figure 2/G).
0 Set the desired start time with the
(Figure 2/D).
0 Set the desired number of cups with
(Figure 2/C).
2-4
0 Set the desired coffee strength with
0 Where applicable (when preparing a
(Figure 2/B). The
5.2 Preparing coffee using the
coffee grinder with pre-pro-
gramming of the start time
(„Auto" function)
(Item 1.4).
1/D) using the swivel lever (Figure 1/H)
until it engages (Figure 13).
Programming the „Auto"function:
(Figure 2/K).
PROG
The green lamp next to the
button (Figure 2/F) flashes. The
AUTO
following settings must be made whilst
the green lamp is flashing.
If the green lamp has already ceased to
flash before the settings are com-
pleted, press button
AUTO
again and continue with the program-
ming.
buttons (Figure 2/E) and
H
(Figure 2/J).
the button (Figure 2/G).
2-10
the button (Figure 2/D).
max. of 4 cups) select the aroma set-
ting with button (Figure 2/C).
2-4
Example:
You require e.g.: Start 08.00 hours,
4 cups, medium strength, with aroma
setting
– the display shows:
The green lamp ceases to flash ca.
3 seconds after the last button actua-
tion. This indicates that the settings are
saved. The display once again shows the
time and the settings in normal mode.
g
(Figure 2/F)
MIN
17