Proline PGC66 WF/1 Bedienungsanleitung Seite 55

5. CLEANING AND MAINTENANCE
To dismantle the oven door
1
Tightening
latch
2
3
Cleaning gas burners
• Remove enamelled
• Clean them with soapy water
• Rinse and dry with a soft cloth (do not leave them wet)
• After cleaning, make sure that you re-assemble the parts correctly.
• Do not clean any part of the cooktop with metal sponge. It causes the surface to be scratched.
• The upper surfaces of
burner flames. These parts will not get rusted and it is not a production fault.
• When cleaning the cooktop plate, make sure that no water flows inside the burners to
blocking the injectors.
Recessed
support
grilles, burner caps and
enamelled grilles may deteriorate over time due to their use and the
To dismantle the oven door
• Open the oven door (1).
• Open the tightening latch up to the final
position (2).
• Close the door until it is almost completely
closed as shown in the third diagram and
remove the door by pulling it.
!
Make sure that the embedded supports are
well positioned on the hinge support as shown in
the second diagram.
Reassembling the door is done
procedure explained above.
tightening latches are well refitted.
crowns (Figure 14).
23
:
by reversing the
Make sure the
avoid