Presentation (Display, Keys); Main Menu; Quick Start Menu - Watts Water Technologies LCD+ Bedienungsanleitung

PRESENTATION
(Display, keys)
T1
1: Simplified drawing of the installation.
- The graphic of the pumps turn when they are
activated.
- The filled triangles on the valve graphic indicate
the circulation
2: Solar loading is in operation.
3: SD card storage is active.
4: Temperature of different sensors, Pumps speed
indications, Power and Energy quantity stored.
A: Keypad description
Navigation key up or plus key (+)
Navigation key down or minus key (-)
Navigation key left (◄)
Navigation key right (►)
Controller information Overview:
An information screen is available to allow you to view quickly
the status of all temperature sensors and outputs connected to
the controller.
From the main display, press (◄) once to display immediately.
The outputs & Inputs screen will be displayed for 1minute,
press (►) at any time to return to the main screen.

Information
T1 xxx°C T2 xxx°C T3 xxx°C
P1 xxx% P2 xxx% P3 x
1 2
3
T1_ _
_°C
SD
T2_ _
T4
_°C
T3_ _
T3
_°C
T4_ _
T2
_°C
A
P1_ _ _
%
_ _ _
KW
_ _ _
KWh
-

Main menu:



4
First of all press (►) to enter on the navigation menu.
(The title of the active menu is highlighted in black on the top of
the display)
When you enter on the navigation menu you can choose
another submenu by moving the selection cursor "
keys (+) or (-), then you can enter this submenu with (►).
From all menus you can press (◄) to return to the previous
menu.
*ATTENTION:
As a safety feature, all critical parameters (System and Extra
function) are not programmable 4 hours after power on. If it is
necessary to modify these parameters, you must power-down
and power-up the controller. No settings are lost when
powering-down, or after a power failure.
After 4 hours it is only possible to alter system optimization
settings.

1 Quick start menu

The "Quick start menu" helps you to configure more easily the
main parameters of your solar controller after the initial
installation.
Power-up the controller and wait until the end of the
initialisation sequence. When the main screen is displayed,
press on the key (►) to access to the "service" menu. Then go
to the bottom of the menu and select the line "Quick start
menu" and press the navigation key (►) once to progress to
the quick start configuration.

English
Time and date
System
Outputs Config.
Inputs Config.
Energy Measurements
Protection func.
Degrees
Tube collectors
Factory setting

Quick Start menu
The controller will guide you through the menu to configure the
main parameters, you will be prompted to adjust the parameter
value by pressing the (+) or (-) input. Press on the (►) key to
validate the display setting and skip to the next parameter.
The controller will return automatically to the main screen when
the configuration process is complete.
4
Information
Services
Settings
Operation
Operation h
Temperatures
Service
-

" with the
-
°F
No
No