Technical Data; Installation; General Installations Notes - SSP ZEUS Betriebsanleitung

2 .7 Technical data

Material
- Housing
- Enabling switch
- Base plate
Ambient conditions
Storage temperature
Operating temperature
Protection class
Air and creepage distance acc. to IEC/EN 606641
- Overvoltage category
- Degree of contamination
Dimensions (without connection cable)
- Width
- Depth
- Height
- Height (emergency stop)
Weight (without connection line)
Operating voltage
Switching elements enabling switch
Enabling switch
Lifetime (reliability values acc. to ISO 13849-1)
- Position 1>2>1
- Position 1>2>3>1
- B10d
Rated operating voltage Ue
Rated operating current Ie
Emergency stop switch / stop switch
Lifetime (reliability values acc. to ISO 13849-1)
- B10d
Rated operating voltage Ue
Rated operating current Ie
Switching capacity
Mechanical lifetime
Torque
Terminal block
Connection cross-section
Number per terminal connection
Terminal blocks
Degree of contamination
Rated operating voltage Ue
Rated current
Cable diameter
Screwed connection
Tensile strength of the connector
Note
Environment: Must not be operated outdoors or in a potentially explosive
atmosphere
4

3 . Installation

3 .1 General installations notes

PA6.6 30% GF, color black
Always use support elements that are suitable for the expected ambient conditions. The
silicon/silicon-free
installation may only be carried out by authorized skilled personnel.
stainless steel 1.4301
-40°C to 80°C
-5°C to 60°C
IP65/IP67 acc. to IEC 529
3
III
Type
69 mm (see base plate)
71 mm
186 mm
24 mm
330 g
24V DC ± 5%
ZEUS
2 changeover contacts
1,000,000 cycles
With the table you can find out the types with the base plate that can be opened and where
100,000 cycles
you can wire the connection.
100,000
DC: 30 V
All functions described in this operating manual are safety-related. Non safety-related
DC: 1 A
functions are described in corresponding additional sheets.
100,000
DC: 30 V
DC: 1 A
AC: 10le / DC: 1.1le
50,000
max. 2.5 Nm
0.14 - 0.34 mm²
7
3
2
DC: 30 V
DC: 1 A
3.5 - 7 mm
M12
20 Nm
Note
The specified protection class is only guaranteed in case of careful observation
of all installation instructions in this operating manual.
Optional safety functions in addition to the enabling switch
without
emer-
emer-
gency
gency
stop switch
stop
switch
switch
00-xxxxxx
x
10-xxxxxx x
20-xxxxxx
01-xxxxxx x
11-xxxxxx x
21-xxxxxx
Information
The fastening bolts of the base plate have to be tightened to 0.5 Nm. If a
corresponding tool is not available, make sure that during tightening of the
base plate the seal is not compressed more than one third.
The sealing of the base plate and the bolts have to be replaced after each opening.
opening of
stop fixed the base
plug
cable plate by the
customer
x
not allowed
x
x x x
allowed
x