Omnitronic MMP-1 Bedienungsanleitung Seite 30

■ If the MMP-1 is operated with mixing function the master signal of player mechanism 1 and 2 is fed to
the MIXED OUTPUT. Connect the output via an RCA cable to the line inputs of an amplifier or active
speaker. Make sure that the right/left occupation (plug color red/white) is the same at both devices.
■ When the mixing function is activated the input channels can be monitored via stereo headphones ahead
of the faders. Connect the headphones to the jack PHONES.
■ If the MMP-1 is operated without mixing function the output signals of the individual player mechanisms
are fed to the corresponding outputs. Connect the outputs via RCA cables to the line inputs of a mixer or
amplifier. Make sure that the right/left occupation (plug color red/white) is the same at the devices.
The player mechanisms of the MMP-1 can be started or set to pause via an external mixer with fader
■
start function. Use the supplied mini jack cables to connect each output CONTROL START to the
corresponding input on the mixer.
Please note that the fader start function only works with compatible mixers (e.g. MX-540, EX-840, EX-820,
CM-860). Mode of operation: The mixer has to be connected via a 3.5 mm jack with the MMP-1. For starting
the playback, the jack's positive pin (tip) is to be connected with the audio mass via a short impulse. For pausing the
playback, the jack's negative pin (sleeve) is to be connected with the audio mass via a short impulse. The mixer has to
be equipped with a switch, button or fader that will connect the tip with the audio mass of the MMP-1 for starting the
playback and the sleeve for pausing the playback when the respective channel is activated.
Connect the MMP-1 to the mains.
■
30/40 00040292.DOC, Version 1.0