Fracarro SIG7100 Betriebsanleitung Seite 25

MEASUREMENT
Bit Error Rate measurement of
the input s ignal
Signal to Noise Ratio
measurement of the input s ignal
Confirm the settings by pressing the
IMPORTANT: The CAM menu depends on the specific model acquired. Full interaction with some types
of CAM might not be possible using the TPE (refer to the technical specifications of the CAM manufac-
turer).
In the "CAM CONTROL" MENU, all the messages from the CAM when it is operating can be displayed; it is also
possible to interact with the CAM using TPE. A message "Not allowed" is displayed in the event that the CAM
does not need the user's intervention. To visualize the CAM MENU use the OSD mode.
COMMON INTERFACE
Confirm the settings by pressing the
5.3.7 MEASUREMENT MENU
SOFTWARE VERSION
BER
S/N (dB)
pressing the S key after the modules programmation.
5.3.8 COMMON INTERFACE MENU
CAM RESET
CAM CONTROL
CI MENU
pressing the S key after the modules programmation.
SIG7100 v. 0
1,3*10E-4
11
key; save the settings by
Reset hardware of
the CAM module
CAM status module
Enter the OSD
navigation of the CAM
key; save the settings by
5
Read-only
Read-only
1=not synchronized signal
Read-only
0=not synchronized signal
verification