Product Installation - Fracarro SIG7100 Betriebsanleitung

• 3 RCA connectors (Yellow -> Video output, White -> Audio Left, Red -> Audio Right);
• 1 slot Common Interface;
• Fixing screw holes to the rack basket;
• Openings for extractors, used for removing the module from sub-rack.
NOTE: For the correct CAM insertion in the slot Common Interface please refer to the Chapter 4.1.
ATTENTION: Refer to the paragraph TECHNICAL SPECIFICATIONS to know the complete list of technical char-
acteristics.
The module SIG7100 is installed in the sub-rack of the New HeadLine series (SIG7901 or SIG790) as is possible
to see in the following photos. Take the module out of its packaging and install it in the required position of the
rack. The packaging contains the following parts:
• N°1 SIG7100 module;
• N°1 75 Ohm load (CA75F);
After the insertion, fix the module
using the screws contained in the
accessory bag. It's a "plug and play"
installation; therefore, the module is
ready to operate.
To remove the module use the handles included in the New Headline sub-rack. Remove from the back-panel the
screws of the module's to be replaced and insert the extractors into the rectangular slots. Rotate the extractors
90° to form a handle. Pull the handle with your hand to extract the module. Be careful because, after a first effort
to detach the module from the bottom panel connectors, the module can be easily removed. While removing the
module, be careful not to touch the covers because they can cause small grazes.

3. PRODUCT INSTALLATION

Fig. 1
16
Insert the module in the card guides
and gently push back to lock them
to the back-panel.
Fig.