Fracarro SIG7100 Betriebsanleitung Seite 23

There is the INPUT menù on detail:
PRESET – it is possible to use the preset (through the function load preset) to help the programming (refer to the
paragraph 5. Preset list) – remember that the preset could not be correct due to modification from the broad-
caster.
LNB – To set the tone 0/ KHz for band selection (High/Low) and the voltage 14/18 V to select the polarity.
DiSEqC – To set DiSEqC depending on the satellite (A, B, C o D).
FREQ.OL (MHz) – Read only value – it is visualized "AUTO".
FREQ.IF (MHz) – To set the IF frequency of the transponder to be received (it is necessary to know this value
before carry out the programming).
SYMBOL RATE – To set the symbol rate of the transponder which has to be received (it is necessary to know this
value before carry out the programming).
FEC – Read only value – it is visualized "AUTO".
SERVICE LIST – To visualize the list of available channels inside the selected transponder. Scrolling the channel
list with the TPE, it is possible to:
• Add a program to the channel list in decryption with the CAM (an asterisk "*" will appears on the second row
of the TPE for the selected program),
• Remove a program from the output channel list for the decryption.
• Show the selected program (the letter "S" will appears on the second row of the TPE for the selected pro-
gram). It is possible to select a program to encrypt.
NOTE: If the program you want to show is MPEG-4 compressed, the following information will appears
on OSD menu: "The selected program is MPEG-4 compressed, it is available in the transport-stream
distributed in the back-panel. MPEG-2 programs are available both in the transport-stream and in RCA
outputs". In this case it will be nevertheless possible to visualize the property also for channel in standard
H.264 and then visualize service ID, PID PCR, PID video and so on.
SERVICE PROPR. – To know the available property for channels, in particular:
• The program name,
• The ID service of the selected program (sum of the three PID values), it is possible to increase or decrease
this value with the TPE arrows or insert a value using the TPE keypad.
• The PID PCR (Program Clock Reference) of the selected program,
• The PID VIDEO of the selected program,
• The PID AUDIO of the selected program (it is possible to select the available values with the TPE),
• The PID TELETEX of the selected program,
• The SUBTITLES, if they are available it will be possible to select their language with the TPE arrows,
• The CHANNEL TYPE (for example FTA, ENC, ...),
• The VIDEO FORMAT of the selected program (for example 4:3, 16:9, ...),
• The AUDIO TYPE IN, the audio type of the selected program (for example stereo).
3