Bosch Indego Originalbetriebsanleitung Seite 39

OBJ_BUCH-1573-009.book Page 39 Tuesday, April 26, 2016 3:20 PM
PIN Code
Enter new PIN:
0 – – –
Back
Select the input position with the left/right cursors, adjust the
digits with the up/down cursors and confirm with "Enter" or
select "Back" to return to the first "PIN Code" screen.
Please make a note of your PIN Code-
PIN CODE
here.
Note: Keep the PIN code secret from third parties.
If you have lost your personal PIN code, you will have to return
the Indego and its docking station to a Bosch Service Center
to be unlocked. Please contact your dealer or Bosch (see "Af-
ter-sales Service and Application Service").
Date & Time
hh:mm
dd/mm/yy
Format: 12 hr
Back
Select the "hh:mm", "dd/mm/yy" and "Format: 12 hr" input
positions with the left/right cursors, adjust the values with the
up/down cursors and confirm with "Save" or select "Back" to
return to the first "PIN code" screen.
Bosch Power Tools
Enter
Press "Follow Wire" to map the garden.
(Select "Back" to return to the "Date & Time" screen.)
Note: If the Indicator on the docking station flashes at this
point the perimeter wire is broken, too long (above 450 m) or
too short (below 20 m).
The following screen indicates the initial follow of perimeter
wire:
Save
The blades do not rotate when the machine follows the wire
for the first time.
Note: Whilst mapping the Indego will follow the wire around
the edge of the lawn area. Where the wire is run to and from
an obstacle within 1 cm as described the Indego will not de-
tect the wire but continue along the wire around the perimeter
of the lawn. (see figure 8)
Installation
Please press Follow Wire to
complete installation process
Follow
Back
Wire
Installation
Step Back
Machine is about to start. Wire
being followed...
Mower Status
Mapping the garden ...
Back
F 016 L81 517 | (26.4.16)
English | 39