hanseatic CJ171JCPQ-070 Gebrauchsanleitung Seite 48

Page EN-16 Operation
Pulling the cord out further
can damage the cable reel.
(23)
red
yellow
1. Pull the mains cord (23) out
until the yellow marking is visi-
ble on the mains cord.
If the red marking is visible, the
mains cord has been pulled
out too far. Allow the mains
cord to retract slightly (see
section "Finishing vacuuming"
on page EN-18).
2. Insert the mains plug (23) into
a properly installed socket.
(9)
3. Use your foot to operate the
on/off foot switch (9), to switch
the appliance on.
4. To vacuum, push and pull the
nozzle across the surface your
are vacuuming.
Rotate the telescopic tube
handle (12) slightly to reach
corners more effectively. This
positions the nozzle diagonally.
In rare cases this can make
a whistling noise initially.
This is not a malfunction
and stops after a while.