Electric Connections - Leb electronics BOOST-Serie Bedienungsanleitung

- To recover the usual working, carry back the panel to the start
position and rotate of 90° counter clockwise the key.
Warning: during the unblocking process, don't force too much
on the key, to avoid breaking it.
Fig. 9

ELECTRIC CONNECTIONS

Warnings
- The reduction gear is to be connected but to a control switchboard
manufactured by the Company LEB.
- All connection operations are to be performed without electric
voltage.
Power supply cable
- From the electric engine four wires come out (230Vac - BOOST 5
and BOOST 10) or two wires (24Vdc - BOOST 24).
- In the following table the data concerning the power supply cable,
required for the connection to the control switchboard, are reported.
BOOST 5 - 230Vac
BOOST 10 - 230Vac
Cable 4 x 1,5 mm
Common
Engine OPEN
Engine CLOSE
Ground
BOOST 24 - 24Vdc
Colour Cable 2 x 1,5 mm
Blue Positive engine input
Black Negative engine input
Brown
Yellow-Green
- 15 -
ENGLISH ITALIANO
Fig. 10
Colour
Green or
Red
Brown or
Black