Leb electronics BOOST-Serie Bedienungsanleitung Seite 14

Set up of the device
- Unscrew the two side screws and remove the cover (Fig. 5).
- Lay the device on the foundation plate paying attention the
anchoring holes match with the slots (Fig. 6).
- Horizontally adjust the distance of the device from the gate. Then
completely tighten the two anchoring screws.
Fig. 5
Rack assembling
- Unblock the reduction gear by the special key.
- Lay the rack on the pinion. Make sure between the pinion and the
rack there is a 1 mm play (fig. 7).
- Fasten the rack to the gate through fitted screws.
- Manually move the gate and check the 1 mm play is maintained on
all the length of the rack.
Fig. 7
Fig. 6
- 13 -
ENGLISH ITALIANO