Leb electronics BOOST-Serie Bedienungsanleitung Seite 10

- This manual is intended but for qualified technical staff and not for
end user. It is a task of the installer to inform afterwards user on the
use of the automatism and on possible dangers could come from it,
as well as on the need of a periodical maintenance.
- The set up is to be carried on only by qualified staff having got
required technical and professional requirements.
- The product is to be installed complying with rules in force about
computer-based closings.
- The device has been realised expressly to automate sliding gates.
Any other employ is to be considered improper and therefore
forbidden.
- Always use original components. The Company LEB doesn't take
any responsibilities for damages due to the use of non-original
components.
- Before proceeding with set up, make sure the gate frame is solid
and fitted for the employ of the device.
- Before proceeding with set up, make sure that, during the gate
move, there are not friction points and that this one has no
possibilities to run off the rails.
- Before acting on the device, check the power supply voltage is
disconnected.
- Fix with a special care the safety devices to be installed and the
place where they are to be positioned. Furthermore insert an
emergency stop device, allowing the forced release of the electric
power supply.
- The equipment is not to be handled by children or incompetents.
- In case of lack of electric voltage, start the unblocking device to
manually open or close the gate.
- The maintenance of the device is to be executed but by qualified
staff authorized by the Manufacturer.
- Six-months check the condition of the gate running wheels is good
and well lubricated.
Warnings
- 9 -
ENGLISH