BEARWARE 303215 Bedienungsanleitung Seite 13

Press the TIME button briefly. You can then configure the second timer pro-
gramme .
A total of 10 timer programmes are available, which you can configure in this
way. Once all the programmes have been customised as needed, please press the
CLOCK button. The display again shows the current time and the day of the week.
The timer is now ready to use.
Note: Please ensure that the times of the individual timer programmes do not over-
lap in order to avoid unintentional switching on or off.
To disable a timer programme again or to enable a disabled program, press the
TIMER button until the desired program is shown in the display. You can now
enable or disable the timer programme using the RES / RCL button.
8. Switching on and off manually
You can manually switch on and switch off the device connected to the timer
using the ON/AUTO/OFF button or enable the automatic control according to the
configured timer programmes again.
Press the button to change between the different modes. The display changes
between "AUTO", "ON" and "OFF".
Please note that when changing from "ON" or "OFF" to "AUTO", the last timer
state is retained until one of the configured timer programmes triggers a change.
9. Random function
The random function allows a random switching delay between the times 6:31
pm and 5:30 am. In the random mode, the timer is randomly switched on and off
with delays up to half an hour.
13
English