BEARWARE 303215 Bedienungsanleitung Seite 12

5. Commissioning
Take the product out of the package and remove all the packaging material. Then,
plug the timer into any socket at home whose voltage matches the specifications
of the timer.
Leave the timer plugged in for about 12 hours so that the backup battery charges
fully. After charging, press the RESET button using a pointed object to clear or
completely reset the current configuration of the timer.
The device is now ready to be used. The following sections of this manual de-
scribe how to make the individual settings.
6. Setting the current time
Press and hold the CLOCK button and simultaneously press the WEEK button until
the current day is shown on the timer display.
Keep the CLOCK button pressed and set the current time using the HOUR and
MINUTE buttons.
Then, release the buttons. The current time and day of the week are now set.
7. Setting the timer programmes
Press the TIMER button briefly. You can first set the time at which the connected
device has to be switched on (ON).
Press the WEEK button until the desired days of the week on which the timer
programme has to be executed are shown on the display. Now set the desired
time using the "HOUR" and "MIN" buttons.
Then press the TIMER button again. You can then set the time at which the
connected device has to be switched off (OFF). Configure the time and days of the
week using the WEEK, HOUR, and MIN buttons as described in the previous step.
Note: Please remember that the days of the week for switching on and switching
off have to be configured separately. The selected combination is not automatical-
ly adopted for the entire timer programme.
12
English