vigo EPK4550E05 Montage- Und Betriebsanleitung Seite 36

While determining the location of the electric panel convector heater, the length
of the cable from the heater to the outlet must be calculated carefully in order
that the cable does not tense and wear out unnecessarily. The legs will be placed
on the floor where the device will be located in a way that they form a straight line
and the centers of the holes thereon will be marked with a pen. Holes at a depth
of 4-5 cm will be drilled on the marked points with drill bit Ø 9 mm. The included
plastic wall plug (6) will be driven into these holes and the legs will be fixed to the
ground with screws and washers.
A sizes;
1000,1300 watt electric panel convector heaters: 305 mm (30.5 cm),
2000 watt electric panel convector heaters: 505 mm (50.5 cm).
The lower part of the device will be placed on the plastic parts (7) that are on the
legs fixed to the ground. The heater will be laid back in the direction of the arrow
(8) and centering plates (9) will be placed in the slots at the back of the heater.
Spring hooks (10) will be placed in the heater holes (11) by pulling them upwards.
In this way, assembly is completed. You can activate your product by electrical
connection to the mains plug.
3
11
1
10
A Sizes
2
8
4
5
A
6
9
7
Figure C
Figure B
34