Safety Instructions - vigo EPK4550E05 Montage- Und Betriebsanleitung

SAFETY INSTRUCTIONS

• Electric panel convector heaters has been adjusted for 220-240 V. Therefore use
the convector only with the Alternative Voltage (AC) and sufficient current rated
power outlets.
• Use your electric panel convector heater with grounded plug socket. Our
company will not be deemed responsible for the damages caused due to usage
without the application of grounding.
• Always operate heater in an upright position. Before operating read montage
instructions carefully.
• Always check heater for black-glass models after you've opened the packaging.
Call the Distributor's Consumer Advisory Hotline in case a breakdown or damage.
Never mount or use your heater. Please refer to the dealer with warranty card
and bill.
• If you use wheel set, heater should be positioned on a flat surface.
• Unplug of your electric panel convector heater from the mains socket while not
in use for long periods and before cleaning.
• Do not place the cord in traffic areas otherwise it may be tripped over.
• Protect your electric panel convector heater against impacts and crushes during
carriage, assembly and usage.
• Do not use your electric panel convector heater for any other purpose than its
intended use for. Do not place cloth thereon.
• Do not operate in areas where gasoline, paint or other flammable liquids are
used or stored.
• Do not immerse in liquid or allow liquid into the interior of the appliance, as this
could create an electric shock hazard.
• Protect the heating cable of your electric panel convector heater against
potential tension possibilities. Do not unplug by pulling on cord.
• Do not operate appliance with wet hands always ensure that hands are dry
before operating any switch on the product or touching the plug.
• This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
24