Werbung
Setting the Digital Address
Important: No address needs to be set for conventional
wiring connections
General Information:
- The address can be set only when the signal control
module with the signal mast connected to it is in its
packaging. (with the address pin snapped into the
packaging on the signal control module).
- The necessary digital components for setting the
address: 1 each Control Unit, 1 each transformer, 1 - 2
Keyboard(s)
- The address is only stored in the home signal.
Button Assignment on the Keyboard:
Block Signal: 1 pair of buttons on the Keyboard
Example:
Signal Type: Two-Aspect Block Signal
Controller: Pair of buttons 5 on Keyboard No. 1 for block
signals.
Procedure for Entering the Address
1. Connect the Control Unit, Keyboard, and transformer.
Do not turn the Control Unit on yet.
2. Leave (!) the signal control module with the home signal
mast connected to it in its original packaging. Connect
14
only the brown and the yellow wires from the signal con-
trol module to the brown and red (!) terminal clips on the
Control Unit.
3. Set the Keyboard address to the desired address. In
our example (Keyboard No. 1) all 4 coding switches at
the "off" position.
4. Turn on the 6021 Control Unit. Press the "stop" button.
5. Press the "go" button. The home signal will begin to
switch between 2 signal aspects. If the following step
does not begin within several seconds (approx. 30 sec.),
the electronic circuit will end the address setting process
automatically.
6. Press the green button on pair of buttons 5 of the
Keyboard until all of the LED's on the home signal light
up. Only release the button at this point.
7. Turn the Control Unit off. The signal and the
signal control module can now be installed on the lay-
out.
Note:
· For long breaks during programming, the signal termi-
nates the programming mode without a change. In this
case, start from the beginning again with the complete
addressing procedure. While addressing is taking place,
ensure that the breaks between the individual keyboard
commands are not too long.
· Once the programming has ended or has been can-
celled, the signal switches to demonstration mode after
a few seconds. In this mode, various signal aspects of
the respective signal type are displayed.
Werbung
