Fellowes POWERSHRED P-48C Bedienungsanleitung Seite 3

OPERATION
Continuous operation:
NOTE:
Safety Lock prevents accidental operation.
To unlock push black button down and slide toward back of shredder. For greater safety, always unplug shredder after use.
TROUBLESHOOTING
Paper jam: Set to Off (O), remove shredder head and empty bin. Replace shredder head, and follow any or
all of the below procedures.
1
2
Set to Reverse (R) Alternate slowly back and forth
for 2-3 seconds
BASIC PRODUCT MAINTENANCE
OILING SHREDDER
performance. If not oiled, a machine may
experience diminished sheet capacity, intrusive
noise when shredding and could ultimately
stop running. To avoid these problems, we
recommend you oil your shredder each time
you empty your waste bin.
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
LIMITED PRODUCT WARRANTY
Limited Warranty: Fellowes, Inc. ("Fellowes") warrants the parts of the machine to be free of
defects in material and workmanship and provides service and support for 2 years from the date
of purchase by the original consumer. Fellowes warrants the cutting blades of the machine to
be free from defects in material and workmanship for 3 years from the date of purchase by the
original consumer. If any part is found to be defective during the warranty period, your sole and
exclusive remedy will be repair or replacement, at Fellowes' option and expense, of the defective
part. This warranty does not apply in cases of abuse, mishandling, failure to comply with product
usage standards, shredder operation using an improper power supply (other than listed on
label), or unauthorized repair. Fellowes reserves the right to charge the consumers for any
Insert waste bag (Fellowes #36052) for easy disposal.
PAPER
1 1 1 2
Set to Off (O) and Check paper amount
plug in
CARD
1 1 1 2
Set to Auto-On (I)
Set to Off (O) and
plug in
To set, wait for shredding to stop, push black button down and slide towards front of shredder.
3 4
Set to Off (O)
and unplug
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
2
1
Set to Off (O)
1 3
Set to Auto-On (I)
3
Hold card at edge
6
5
Gently pull uncut Set to Reverse (R)
paper from paper
entry. Plug in.
3
* Apply oil Set to Reverse (R)
across entry for 2-3 seconds
additional costs incurred by Fellowes to provide parts or services outside of the country where the
specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide,
more details or to obtain service under this warranty, please contact us or your dealer.
1 5
4
Feed into paper Set to Off (O)
entry and release
1 5
4
Set to Off (O)
Shredder doesn't start:
Make sure head is on basket correctly
Wait 15 minutes for motor to cool down
Remove and empty basket
Make sure safety lock is in
unlock position
3