Ca-Mi T-Flash Bedienungsanleitung Seite 21

Cura e Note: Please check the device if damaged once it falls.
Pulizia
If you can't make sure of it ,please send the complete
device to the nearest retailer for recalibration.
Holding the thermometer too long may cause a higher
ambient temperature reading of the probe. This could
make the body temperature measurement lower than
usual.
Battery Open the battery cover (Fig. 1): insert a pointed object,
replacement
such as a pen, into battery cover pick hole (Fig. 2).
At the same time, use thumb to push battery cover out
(Fig. 3). Hold the device and flip the battery out with a
small screwdriver.
Insert the new battery under the metal hook on the left
side and press the right side of the battery down until
you hear a click.
Replace the battery cover. Keep the battery away from
children. (This device is supplied with one lithium cell
(CR2032x1).
The positive (+) side up and the negative (–) side
pointed down.
Error
Message
Fig. 1
TROUBLESHOOTING
Problem
Error 5÷9, the system is
not functioning properly.
M e a s u r e m e n t b e f o r e
device stabilization.
The ambient temperature
is not within the range
between 10° C and 40° C
(50° F ÷ 104° F).
Fig. 2
Unload the battery, wait
for 1 minute and repower
it. If the message reappears,
contact the distributor
customer service.
Wait until all the icons
stops flashing.
21
Fig. 3
Solution
GB