Ca-Mi T-Flash Bedienungsanleitung Seite 19

Functions
°C/°F Switch
USE OF THE THERMOMETER
1. Always make sure the probe is clean, and without damage.
2. Power on: Press "ON/MEM" button (POS. 4).
3. Mode selection:
3.1 Forehead mode: Forehead mode is the default mode. You
can see the icon
3.2 Scan Mode: Press and hold the "ON/MEM" button, and
press the "SCAN" button one time, you can see the icon
on your LCD display. In this mode, press the "SCAN"
button to get the target surface temperature.
4. Temperature taking:
4.1 Forehead temperature measuring, points for
attention:
- In this mode, you can hold the thermometer 1 to
3 cm from the central forehead (Fig. 4.1) and press
Fig. 4.1
the "Scan" button to get the forehead measurement.
The time consuming for measurement might be 1 second.
- Forehead temperature is displayed in oral mode. This mode
converts the forehead temperature to display its "oral-
equivalent" Value.
- Before the measurement, please stay in a stable environment
for 5mins and avoid exercise, bath for 30mins.
- Remember to keep the temple area clean and away from
sweat, cosmetics and scar while taking temperature.
Clinical accurancy data:
- Clinical Bias: – 1.4° C ÷ – 1.7° C.
--> In "power off" mode (The LCD only
shows the date, time and room temperature).
Press and hold the "SCAN" button, then
immediately press and release the
"ON/MEM" button. After 3 seconds, icon "°
C" will be switched to icon "° F". (You may
use the same way to switch back to "° C").
on the screen and hear two beep sounds.
19
GB