Maintenance Instructions - Desoutter EFDE Serie Bedienungsanleitung

English
● Mount the spindle and the module onto the
clamping plate (see "Figure A").
It is possible to rotate the connector by loosening
the two screws that freeze the position (see
"Figure B").
Recommendations for cable management
● Plug the cable with help of TOP indication.
(see "Figure C").
The cable shall not apply traction to the tool.
Any traction force on the cable (even low
intensity depending on the cable orientation) can
generate a torque signal on the transducer.
The cable management must ensure no stress is
applied to the torque transducer. This statement
must be fulfilled at cycle start to avoid "offset
failure" error messages and absolutely secured
once the tightening job is running.
● Check the cables are long enough or clamp
the tool cable on the mounting plate (see
"Figure D").
● Do not set up the tool as described in
"Figure E".
CONTROL AND SOFTWARE
Power supply by means of CVI3 controller with
the appropriate embedded program version.

MAINTENANCE INSTRUCTIONS

Overhaul and preventive maintenance
is recommended at regular intervals
once per year or after maximum
500,000 tightenings depending on
which occurs sooner.
Maintenance should be performed by qualified
personnel only.
● Prior to any maintenance task, disconnect the
tool.
Assembly and disassembly
● When disassembling/reassembling the tool,
take the following precautions:
- Check that the controller is switched off.
- Disconnect the cable.
● When disassembling the tool electronics, take
extra care for the wires when pulling out the
connectors.
● Follow standard engineering practices and
refer to figures/exploded view for the mounting
of component subassemblies.
11/2016
Meaning of the pictograms
Left hand thread
When reassembling, apply the
recommended glue
When reassembling, tighten to the
required torque
When reassembling, lubricate with the
required grease or oil.
Lubrication
● Do not apply too much grease on
gears or bearings; a thin coat shall
be sufficient.
The use of spare parts other than those
originally supplied by the manufacturer
may result in a drop in performance or
in increased maintenance and level of
vibration and in the full cancellation of
the manufacturer's liability.
According to Directive 2012/19/CE
concerning Waste Electrical and
Electronic Equipment (WEEE), this
product must be recycled. Please
contact your "Customer Centre"
or consult the website "www.
desouttertools.com" to find out where
you can recycle this product.
41 / 92
6159939410_09