Troubleshooting; Troubleshooting Battery Or Cordless Product - Stihl AR 2000 L Gebrauchsanleitung

19 Troubleshooting

19 Troubleshooting

19.1 Troubleshooting Battery or Cordless Product

Condition LEDs and Beeps
Cordless product 1 LED flashes
does not run after green and 6 long
switch-on or cuts out beeps sound.
during operation.
1 LED glows red.
3 LEDs flash red.
3 LEDs glow red.
4 LEDs flash red
and short beeps
sound in quick
succession.
Runtime of cordless
product is too short.
0458-820-9921-A
Cause
Battery has low charge.
Battery too hot or too cold. ► Disconnect the battery.
There is a malfunction in
the battery.
Cordless product too hot.
There is a malfunction in
the battery.
No electrical contact
between cordless product
and battery.
Cordless product or battery
damp.
Battery not fully charged.
Normal battery life has
been exceeded.
Remedy
► Recharge the battery fully as described in the
instruction manual for the STIHL AL 300 and AL
500 chargers.
► Allow battery to cool down or warm up.
► Disconnect battery and then reconnect it.
► Switch on the cordless product.
► If 3 LEDs continue to flash red: Contact a STIHL
servicing dealer for assistance.
► Disconnect the battery.
► Wait for cordless product to cool down.
► Take the battery off your back.
► Disconnect battery and then reconnect it.
► Switch on the cordless product.
► If 4 LEDs continue to flash red and short beeps
sound in quick succession: Do not use or transport
the battery, contact your STIHL servicing dealer.
► Disconnect battery and then reconnect it.
► If the cordless product still does not run when
switched on or cuts out during operation: Clean
contacts of the connecting cable.
► Allow cordless product / battery to dry.
► Recharge the battery fully as described in the
instruction manual for the STIHL AL 300 and AL
500 chargers.
► Replace the battery.
English
43