Autophix 7910 Bedienungsanleitung Seite 17

3.5 Evap Leak Test
This function enables the conditions required to conduct an
evaporative system leak test, but does not actually run the test.
The vehicle manufacturer is responsible to determine the
criteria to automatically stop the test.
Before performing this function, please check the vehicle's
service repair manual to determine the necessary procedures.
Diagnostic Menu
Read Codes
Erase Codes
I/M Readiness
Data Stream
Evap System Test
Vehicle Information
3.6 Vehicle Information
Select [Vehicle Information] and press [ENTER],the screen will
display the information such as VIN (Vehicle identification
Number），CID（Calibration ID）and CVN (Calibration verify
number).
Diagnostic Menu
Read Codes
Erase Codes
I/M Readiness
Data Stream
Evap System Test
Vehicle Information
Evaportive system leak test
not supported
5/6
Vehicle Identification Number(VIN):
LVSFBFAC94F020950
Calibration Identifications(CID):
000007550753
Calibration Verification Numbers(CVN):
B5073064
6/6
16
Evap System Test
Vehice Information